2. Verb. (third-person singular of slot) ¹
¹ Source: wiktionary.com
Definition of Slots
1. slot [v] - See also: slot
Lexicographical Neighbors of Slots
Literary usage of Slots
Below you will find example usage of this term as found in modern and/or classical literature:
1. Electrical Engineering: The Theory and Characteristics of Electrical by Clarence Victor Christie (1917)
"ir- vanes from 1 to 2 for open slots and the ratio -,—7—5—iu vanes from 2 to 3.5
or 4. slot depth slot depth . ,, „ 295. Regulation. ..."
2. International Library of Technology: A Series of Textbooks for Persons by International Textbook Company (1908)
"Shape of slots.—There has been much discussion in regard to the best form of ...
Entirely closed slots are used comparatively little, as the bridge of iron ..."
3. Principles of Alternating Current Machinery by Ralph Restieaux Lawrence (1920)
"Both have slots which are usually partially closed. Very open slots are undesirable
as they would materially increase the effective length of the air gap. ..."
4. Maintaining Budgetary Discipline: Spending and Revenue Options edited by Sherry Snyder (1999)
"The Federal Aviation Administration (FAA) has established controls on airport
takeoff and landing slots at four airports: Kennedy International and La ..."
5. Principles of Direct-current Machines by Alexander Suss Langsdorf (1919)
"Shape of Teeth and slots.—Fig. 52 illustrates typie.il forms of teeth and ...
Where semi-closed slots are used, the coils may be formed on a winding jig, ..."
6. Armature Winding and Motor Repair: Practical Information and Data Covering by Daniel Harvey Braymer (1920)
"For sliding top sides of coils into slots. For driving coils into slots. ...
For lifting tight coils out of slots. For marking location and pitch of coil ..."
7. Armature Winding and Motor Repair: Practical Information and Data Covering by Daniel Harvey Braymer (1920)
"For sliding top sides of coila into slots. For driving coils into slots. ...
For lifting tight coils out of slots. For marking location and pitch of coil ..."
8. Machine Tool Operation by Henry D. Burghardt (1922)
"slots, Tongues, Grooves, Keyways, Keyseats, Dovetails, have been described in
the chapter on shaper work beginning page 100. 138. Planing T-slots—Use of ..."
Other Resources:
